[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen items
(Trouble diagnosis content)
DTC detection condition
U1CA9-02Blower motor assembly RL comm
(Blower motor assembly rear left communication)
Diagnosis conditionEngine running
Signal (terminal)LIN (heated seat) signal (terminal #45)
ThresholdA/C amp. is not transmitting or receiving LIN communication with rear seat heater LH
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
  • Fuse
  • Harness or connectors (Rear seat heater LH circuit is open or short to ground)
  • Rear seat cushion heater LH
  • A/C amp.
 
 
FAIL-SAFE
—
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Start the engine.
  2. Check “Self Diagnostic Result” of “HVAC” using M.U.T.-III SE.
Is DTC detected?
Refer to Diagnosis Procedure.
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END