Disassembly and Assembly
caution
When disassemble, always use the remover tool that is made by plastic to prevent damage to the parts.
DISASSEMBLY
1.
Disengage fixing portion by direction arrow as shown in figure, and then remove ISO FIX bracket cover.
2.
Disengage fixing pawls according to numerical order 1￫4 using a remover tool (A), and then remove ISO FIX bracket finisher.
: Pawl
: Vehicle front
3.
Remove fixing screws
, and then remove seat cushion harness bracket from seat cushion pad.
4.
Disengage harness and harness connector fixing clips, and then remove seat cushion harness bracket.
: Clip
5.
Disconnect harness connector, and then remove seat cushion harness.
6.
Remove hog rings, and then separate seat cushion trim and pad.
caution
Before separating, check the installation position of hog rings.
Never disassemble heater unit and occupant detection sensor from seat cushion pad.
ASSEMBLY
Note the following items, and then assemble in the reverse order of disassembly.
caution
For hog ring that is removed or crimped unsuccessfully, fix it by using a new hog ring. (Never reuse hog ring.)
Always install the hog rings in position.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
)
, and then remove seat cushion harness bracket from seat cushion pad.)
)
