[Previous][Next]
DTC Diagnosis Procedure
1.CHECK CIRCUIT BETWEEN CVT UNIT AND GROUND
  1. The ignition switch is OFF.
  2. Disconnect TCM connector and CVT unit connector.
  3. Check continuity between TCM harness connector terminal and ground.
    TCM—Continuity
    ConnectorTerminal
    F7530GroundNot existed
Is the inspection result normal?
.
Repair or replace damaged parts.
 
2.CHECK CIRCUIT BETWEEN CVT UNIT AND CONTROL GROUND
Check resistance between CVT unit harness connector terminal and ground.
CVT unit—ConditionResistance
ConnectorTerminal
F2091GroundCVT fluid temperature: 20°C (68°F)5.5 – 7.0 Ω
CVT fluid temperature: 50°C (122°F)6.0 – 8.0 Ω
CVT fluid temperature: 80°C (176°F)6.5 – 8.5 Ω
Is the inspection result normal?
.
There is malfunction of line pressure solenoid valve circuit. Replace control valve. Refer to Removal and Installation.
 
3.CHECK CIRCUIT BETWEEN CVT UNIT AND CONTROL VALVE
  1. Disconnect control valve connector. Refer to Removal and Installation.
  2. Check continuity between CVT unit harness connector terminal and ground.
    CVT unit—Continuity
    ConnectorTerminal
    F2091GroundNot existed
Is the inspection result normal?
.
Replace terminal cord assembly. Refer to Removal and Installation.
 
4.CHECK CIRCUIT BETWEEN CONTROL VALVE AND GROUND
Check resistance between control valve harness connector terminal and ground.
Control valve—ConditionResistance
Terminal
1GroundCVT fluid temperature: 20°C (68°F)5.5 – 7.0 Ω
CVT fluid temperature: 50°C (122°F)6.0 – 8.0 Ω
CVT fluid temperature: 80°C (176°F)6.5 – 8.5 Ω
Is the inspection result normal?
INSPECTION END
There is malfunction of line pressure solenoid valve. Replace control valve assembly. Refer to Removal and Installation.