[Previous][Next]
DTC Diagnosis Procedure
1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT
  1. The ignition switch is OFF.
  2. Disconnect TCM connector and CVT unit connector.
  3. Check continuity between TCM harness connector terminal and ground.
    TCM—Continuity
    ConnectorTerminal
    F7512GroundNot existed
Is the inspection result normal?
.
Repair or replace malfunctioning part.
 
2.CHECK TERMINAL CORD ASSEMBLY
Check continuity between CVT unit connector terminal and ground
CVT unit—Continuity
ConnectorTerminal
F20912GroundNot existed
Is the inspection result normal?
.
Replace terminal cord assembly. Refer to Removal and Installation.
 
3.CHECK CVT FLUID TEMPERATURE SENSOR
Check resistance between CVT unit connector terminals.
CVT unitConditionResistance
(Approx.)
ConnectorTerminal
F20912 – 18CVT fluid temperature: 20°C (68°F)6.5 kΩ
CVT fluid temperature: 50°C (122°F)2.2 kΩ
CVT fluid temperature: 80°C (176°F)0.87 kΩ
Is the inspection result normal?
INSPECTION END
Replace terminal cord assembly. Refer to Removal and Installation.