[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P07E800T/M RANGE CONTROL
(Transmission Range Control Circuit/Open)
Diagnosis conditionIgnition switch: ON
SignalElectric shift sensor signal
ThresholdThe input voltage is more than 4.5 V in one of electric shift sensors No.1 to No.8.
Diagnosis delay time2.4 seconds
 
 
POSSIBLE CAUSE
  • Electric shift selector (Electric shift sensor)
  • Electric shift control module
  • Harness or connectors (Electric shift sensor circuit is open.)
 
 
FAIL-SAFE
Not changed from normal driving
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. The ignition switch is ON and wait for at least 5 seconds.
  2. Shift the selector lever to "R" position and hold for at least 5 seconds.
  3. Shift the selector lever to "D/M" position and hold for at least 5 seconds.
  4. Check DTC.
Is DTC detected?
Go to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END