DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P06B1*	00	SENSOR POWER SUPPLY A (Sensor Power Supply "A" Circuit Low)	1	Diagnosis condition	When the Ignition switch is ON
				Signal (terminal)	Electric shift sensor signal
				Threshold	Electric shift sensors No. 1, 3, 5 and 7 are stuck at OFF.
				Diagnosis delay time	—
			2	Diagnosis condition	When the Ignition switch is ON
				Signal (terminal)	Electric shift sensor signal
				Threshold	Electric shift sensors No. 2, 4, 6 and 8 are stuck at OFF.
				Diagnosis delay time	—

*: This code is displayed as P0914 on GST.

Shift position judgement table

Select lever position	Electric shift sensor
Select lever position	No. 1	No. 2	No. 3	No. 4	No. 5	No. 6	No. 7	No. 8
R	ON	ON	OFF	OFF	OFF	OFF	OFF	OFF
Nr	ON	ON	ON	ON	ON	OFF	OFF	OFF
H	ON	ON	ON	ON	ON	ON	ON	ON
Nd	OFF	OFF	OFF	ON	ON	ON	ON	ON
D/M	OFF	OFF	OFF	OFF	OFF	OFF	ON	ON

POSSIBLE CAUSE

Harness or connectors (Electric shift sensor circuits are open or shorted.)
Electric shift sensor
Electric shift control module

FAIL-SAFE

Determination time of the shift selector position becomes long (1 second or more)

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.

2.PERFORM DTC CONFIRMATION PROCEDURE

The ignition switch is ON.
Select “Data List” in “SHIFT”.
Select “Shift position judgment”.
Shift the selector lever as follows. (Hold the selector lever at each position for 2 seconds or more.)
H → Nr → R → Nd → D/M → H
Repeat step 4 five times.
Check DTC.

Is “P06B1-00 detected?

Go to DTC Diagnosis Procedure

-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END