[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P066600CONTROL MODULE TEMP SENSOR
(Control Module Internal Temperature Sensor "A" Circuit)
Diagnosis conditionIgnition switch: ON
Signal-
ThresholdThe difference between the measured temperatures of thermistor 1 and thermistor 2 is more than the specified value.
Diagnosis delay time4 seconds
 
 
POSSIBLE CAUSE
Electric shift control module
 
 
FAIL-SAFE
Not changed from normal driving
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. The ignition switch is ON and wait for at least 5 seconds.
  2. Check DTC.
Is DTC detected?
Go to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END