[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
U007300Control module comm Bus A Off
(Control Module Communication Bus A Off)
Diagnosis conditionWhen the ignition switch is ON
SignalCAN communication signal
ThresholdTCM communication blockage (Communication not established)
Diagnosis delay time2 seconds
 
 
POSSIBLE CAUSE
Harness or connector (CAN communication line is error)
 
 
FAIL-SAFE
  • Selector shock is large
  • Start is slow
  • Acceleration is slow
  • Lock-up is not performed
 
 
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another “DTC CONFIRMATION PROCEDURE” occurs just before, the ignition switch is OFF and wait for at least 10 seconds, then perform the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine and wait for at least 5 seconds.
  2. Check the DTC.
Is “U0073–00” detected?
Go to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END