DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P0713	00	FLUID TEMP SENSOR A (Transmission Fluid Temperature Sensor A Circuit High)	Diagnosis condition	When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V Vehicle speed: More than 10 km/h (7 MPH)
			Signal	CVT fluid temperature sensor signal
			Threshold	Fluid temperature sensor detection voltage: 2.48 V or more
			Diagnosis delay time	5 seconds

POSSIBLE CAUSE

Harness or connector (CVT fluid temperature sensor circuit is open or shorted to power supply)
CVT fluid temperature sensor

FAIL-SAFE

Engine coolant temperature when engine start: Temp. ≥ 10°C (50°F)
- Start is slow
- Acceleration is slow
Engine coolant temperature when engine start: −35°C (−31°F) ≤ Temp. < 10°C (50°F)
- Selector shock is large
- Start is slow
- Acceleration is slow
Engine coolant temperature when engine start: Temp. <−35°C (−31°F)
- Selector shock is large
- Start is slow
- Acceleration is slow

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch is OFF and wait for at least 10 seconds, then perform the next test.

2.PERFORM DTC CONFIRMATION PROCEDURE

Start the engine.
Maintain the following condition for 10 seconds or more.
Vehicle speed : 20 km/h (12 MPH) or more
Stop the vehicle.
Check the first trip DTC.

Is “P0713–00” detected?

Go to Diagnosis ProcedureDTC Diagnosis Procedure

-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END