DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P060B	00	CONTROL MODULE (Internal Control Module A/D Processing Performance)	Diagnosis condition	Ignition switch: ON
			Signal	-
			Threshold	When an analog-to-digital conversion error is detected.
			Diagnosis delay time	10 ms

POSSIBLE CAUSE

TCM

FAIL-SAFE

Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

2.PERFORM DTC CONFIRMATION PROCEDURE

The ignition switch is ON.
Check DTC.

Is DTC detected?

Go to Diagnosis Procedure

-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END