DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P2413	00	EGR SYSTEM (EGR system performance)	Diagnosis condition	Engine run at idle condition.
			Signal (terminal)	—
			Threshold	Signal amplitude below a specified range.
			Diagnosis delay time	—

POSSIBLE CAUSE

Harness or connectors (The EGR volume control valve circuit is open or shorted.)
EGR volume control valve

FAIL-SAFE

Fail safe mode

Vehicle behavior

Traveling control mode

Accelerator angle variation control

ECM controls the accelerator pedal depression speed to make it slower than actual speed. This causes a drop in accelerating performance and encourages the driver to repair malfunction.

note	ECM does not control the accelerator pedal releasing speed.

Device fix mode

This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position.
The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).
A control signals is not transmitted to EGR volume control valve and the EGR volume control is deactivated.

DTC Confirmation Procedure

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

2.PERFORM DTC CONFIRMATION PROCEDURE

Start the engine.
Check 1st trip DTC.

Is 1st trip DTC detected?

Proceed to DTC Diagnosis Procedure

-1To check malfunction symptom before repair: Refer to Intermittent Incident Intermittent Incident

-2Confirmation after repair: INSPECTION END