[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P222700Barometric Pressure Sensor "A" Circuit Range/Performance
(Barometric Pressure Sensor "A" Circuit Range/Performance)
Diagnosis conditionIgnition switch ON
Signal (Terminal)―
ThresholdECM detects internal electrical error.
Diagnosis delay time5 seconds or more
 
 
POSSIBLE CAUSE
ECM
 
 
FAIL-SAFE
Fail safe modeVehicle behavior
Traveling control modeEngine output controlECM reduces the engine output, according to the rise in engine speed. This reduces the vehicle speed to encourage the driver to repair malfunction.
  • Driving at 70 km/h (44 MPH) or more is possible.
noteThis value is a reference value converted from engine power to vehicle speed. Actual power limitation value differs due to the malfunctioning part and driving condition.
Device fix mode
  • This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position.
  • The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).
  • A control signals is not transmitted to EGR volume control valve and the EGR volume control is deactivated.
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn ignition switch ON and wait at least 10 seconds.
  2. Check 1st trip DTC.
Is DTC P2227 detected?
Refer to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END