DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P1A10	00	ECM initial learning Incomplete (ECM initial learning Incomplete)	Diagnosis condition	Ignition switch ON
			Signal (terminal)	—
			Threshold	When drive distance will be less than 96 km (60 miles) and ECM keeps initial state to replace ECM will indicate DTC.
			Diagnosis delay time	—

POSSIBLE CAUSE

ECM initial learning not complete

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

2.PERFORM DTC CONFIRMATION PROCEDURE

With M.U.T.-III SE

Turn ignition switch ON.
Check 1st trip DTC.

Is 1st trip DTC detected?

Proceed to DTC Diagnosis Procedure

-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END