[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P160300CONTROL MODULE
(CONTROL MODULE)
Diagnosis condition—
Signal (terminal)—
ThresholdEEPROM (built-in microcomputer) system internal ECM does not function properly
Diagnosis delay time—
 
 
POSSIBLE CAUSE
ECM
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
Perform the following procedure before performing DTC Confirmation Procedure.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine and wait at least 10 seconds.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Repeat steps 1 and 2 for 4 times.
  4. Turn ignition switch ON.
  5. Erase DTC.
  6. Turn ignition switch OFF and wait at least 10 seconds.
  7. Start the engine and wait for 10 seconds.
  8. Check 1st trip DTC.
Is 1st trip DTC detected?
Refer to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END