[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P033500CKP SEN/CIRCUIT
(Crankshaft position sensor “A” circuit)
Diagnosis conditionEngine running or cranking
Signal (terminal)Crankshaft position sensor (POS) signal
Threshold
  • The crankshaft position sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking
  • The proper pulse signal from the crankshaft position sensor (POS) is not sent to ECM while the engine is running
Diagnosis delay time—
 
 
POSSIBLE CAUSE
  • Harness or connectors [Crankshaft position sensor (POS) circuit is open or shorted.]
  • Crankshaft position sensor (POS)
  • Signal plate
 
 
FAIL-SAFE
Engine operating condition in fail-safe mode
Fail safe modeVehicle behavior
Device fix mode
  • This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position.
  • The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).
  • A control signals is not transmitted to EGR volume control valve and the EGR volume control is deactivated.
 
 
DTC Confirmation Procedure
1.CHECK DTC PRIORITY
If DTC P0335 is displayed with DTC P06B0, first perform the trouble diagnosis for DTC P06B0.
Is applicable DTC detected?
Perform diagnosis of applicable. Refer to DTC Description.
.
 
2.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10.5 V with ignition switch ON.
: .
 
3.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start engine and let it idle for at least 5 seconds.
    If engine does not start, crank engine for at least 2 seconds.
  2. Check 1st trip DTC.
Is 1st trip DTC detected?
Proceed to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END