[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P026200CYL1 INJECTOR
(Cylinder 1 Injector A Circuit High)
Diagnosis condition
Signal (terminal)
Threshold
  • Direct injector driver unit is malfunctioning.
  • ECM detects direct fuel injector No. 1 circuit is shorted.
Diagnosis delay time
 
 
POSSIBLE CAUSE
  • Harness or connectors
    • Direct fuel injector circuit is shorted
  • Battery power supply
  • ECM (direct injector driver unit)
  • direct fuel injector
 
 
FAIL-SAFE
Engine operating condition in fail-safe mode
Fail safe modeVehicle behavior
Traveling control modeAccelerator angle variation controlECM controls the accelerator pedal depression speed to make it slower than actual speed. This causes a drop in accelerating performance and encourages the driver to repair malfunction.
noteECM does not control the accelerator pedal releasing speed.
Device fix mode
  • This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position.
  • The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).
  • A control signals is not transmitted to EGR volume control valve and the EGR volume control is deactivated.
Combustion control modeStratified charge combustion control at startingNo stratified charge combustion at starting (cold start).
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
  • Before performing the following procedure, confirm that battery voltage is between 12 - 15 V at idle.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start engine and let it idle for at least 20 seconds.
  2. Check 1st trip DTC.
Is 1st trip DTC detected?
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END