Component Inspection
1.
CHECK INTAKE AIR TEMPERATURE SENSOR
Turn ignition switch OFF.
Disconnect mass air flow sensor harness connector and reconnect it again.
Turn ignition switch ON.
Select “DATA MONITOR” mode with M.U.T.-III SE.
Check that “INT/A TEMP SE” indicates as per following condition.
Monitor item
Condition Value
Values
INT/A TEMP SE
Temperature [°C (°F)]
25 (77)
20 - 30°C (68 - 86°F)
80 （176）
75 - 85°C (167 - 185°F)
Is the inspection result normal?
INSPECTION END
Replace mass air flow sensor (with intake air temperature sensor). Refer to
Exploded View
.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
INSPECTION END
Replace mass air flow sensor (with intake air temperature sensor). Refer to Exploded View
.