[Previous][Next]
Component Function Check
1.CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION
  1. Turn ignition switch ON.
  2. Connect M.U.T.-III SE and select “DATA MONITOR” mode.
  3. Select “LOAD SIGNAL” and check indication under the following conditions.
    Monitor itemConditionIndication
    LOAD SIGNALRear window defogger switchONON
    OFFOFF
Is the inspection result normal?
.
Refer to Diagnosis ProcedureDTC Diagnosis Procedure.
 
2.CHECK LIGHTING SWITCH FUNCTION
Check “LOAD SIGNAL” indication under the following conditions.
Monitor itemConditionIndication
LOAD SIGNALLighting switchON at 2nd positionON
OFFOFF
Is the inspection result normal?
.
Refer to Diagnosis ProcedureDTC Diagnosis Procedure.
 
3.CHECK HEATER FAN CONTROL SWITCH FUNCTION
Select “HEATER FAN SW” and check indication under the following conditions.
Monitor itemConditionIndication
HEATER FAN SWHeater fan control switchONON
OFFOFF
Is the inspection result normal?
INSPECTION END
Refer to Diagnosis ProcedureDTC Diagnosis Procedure.