[Previous][Next]
Flushing
 
 
1. Install reservoir tank if removed and radiator drain cock.
caution
  • Be sure to clean the drain plug.
  • Do not reuse O-ring.
Radiator drain cock: Refer to Exploded View.
  • If water drain plugs on cylinder block are removed, close and tighten them. Refer to Setting.
2. Fill radiator and reservoir tank with water and reinstall radiator cap.
3. Run the engine and warm it up to normal operating temperature.
4. Rev the engine two or three times under no-load.
5. Stop the engine and wait until it cools down.
6. Drain water from the system. Refer to Draining.
7. Repeat steps 1 through 6 until clear water begins to drain from radiator.